Kiln dried hardwood lumber is used for the foundation of each frame. All frames are cut precisely and assembled by hand using select 5/4''hardwoods, which are then joined by glue and double-dowels to strengthen and reinforce the frame. The 4 corners of the frame are reinforced with corner blocks which are glued, screwed, and stapled to the frame, a process that triples the strength and stability of the frame. All frames are sanded along the edges to create softer lines and eliminate hard edges that over time can be abrasive to upholstery material.
Steel bands are stretched under strips of webbing and are double nailed to the frame. This is the foundation for the spring chamber which adds incredible strength and eliminates the possibility of any future sagging.Eight-way hand-tied double cone coil springs are securely nailed to the hardwood frame and offer the ultimate in firm support and long lasting comfort. Eight-way hand tying is an age-old construction technique...passed down through generations of craftsmen and women. It is an art which takes time and patience... but for exquisite comfort... there is NO substitute! We combine the best of traditional hand craftsmanship and modern technology to produce frames that are among the finest in the upholstery business
Each frame is upholstered by an experienced craftsman with great attention to detail. Layers of cotton batting and pre-formed rubber are used throughout the frame for unseen form and luxurious comfort. Many frames are standard with accent nails which are meticulously applied one at a time by the hands of an experienced craftsman.
We use a variety of reclaimed and sustainably sourced woods such as: plantation-sourced birch, elm, fir, sheesham, acacia, and other aged woods.
A clear lacquer finish is used on our furniture. We do not apply a wax finish; however, a wax can be applied
We take pride in everything we build. Here are just a few aspects of the products we build: Chair legs and frames are reinforced by both gluing and screwing a large corner brace into each corner after the frame and leg have been joined together with mortise and tenon construction. Dining legs are connected by a reinforced V-grooved corner block and two bolts that work together to create the most sturdy frame available in order to eliminate any movement. Our case goods are deeper and our drawers are full extension with soft closing guides
Choose from seven kinds of wood and 30 finish options. We use a commercial grade catalyzed varnish to protect all our furniture. We seal all sides of the furniture, such as the underside of the table, bottom of chairs, etc.
You will need to register with us as the original owner of Fusion Design furniture. Should the properly maintained furniture fail at any time during the ownership and lifetime of the original owner because of workmanship, not because of normal use, misuse, neglect or abuse, or exposure to extreme heat, cold, or humidity, we will either repair or replace it upon our discretion. This warranty does not apply to any damage in transit or freight costs to and from factory. Fusion Designs is not responsible for gapping or seasonal cracking on items after 2 years. 1 year warranty on electronics.
(1) Use only cold water when cleaning to avoid shrinkage, (2) If spills occur blot immediately then spot clean with mild soap and cold water, (3) Do not use oxygen cleaners on your rug, (4) Avoid direct sunlight to prevent fading, (5) For best results, periodic professional cleaning is recommended.
Placing the correct size rug in your space is as important as choosing the right color or pattern. A rug that it is too small will shift the balance of the room unfavorably. A rug that is too big, especially in open floor plans, may put the area designations off. There are a few rules of thumb, but a picture says it better. Use these handy guides by Interior Designer Lisa Ferguson to make the best choice.